james

[james]

usually that rating is in tension, not bending at the shank.

So, you think I should go up to a 3/4? 1"?


Sent from my DROID RAZR using Tapatalk 4 Beta

 

[97TJGUZZY]

you have it built already, I would see if it bends, it may be fine. I would try to make sure you have as little threads exposed as possible.

 

[WolfGT]

FYI james, your avatar isn't showing. It looks like everyone elses is, but not yours.

 

[97TJGUZZY]

FYI james, your avatar isn't showing. It looks like everyone elses is, but not yours.

I think thats the same problem another member was having. I sent an email to tech about it this morning.

 

[james]

you have it built already, I would see if it bends, it may be fine. I would try to make sure you have as little threads exposed as possible.

I figured 5/8 would have been plenty strong enough....was just reading about a cj bending 3/4".... If there's any exposed I'll try to run some type of spacer.... Extra nut or something

Sent from my DROID RAZR using Tapatalk 4 Beta